94
Settings for energy saving
Energy saving
5
Touch [Register].
z The “Setting” dialogue closes.
z To cancel the settings, touch [Cancel].
5
6
Set other outdoor units.
z Repeat steps 3 to 5.
7
Select “Yes” for “O/D unit demand”.
7
8
Touch [Register].
z To cancel the settings, touch [Cancel].
8
The “O/D unit demand settings” screen
A: [Select all]/[Clear all] buttons
[Select all] Select all outdoor units.
[Clear all] Cancel selection of all
outdoor units.
B: Set whether to enable outdoor unit demand
control or not.
Note
y If you select “Yes”, make sure that you set
“No” for indoor unit demand settings.
C: This switches between “Display” and
“Address” each time you touch it.
D: The outdoor units with a check mark next to
them will be the subject of the changes to the
settings.
E: The O/D unit demand setting is enabled for
the selected outdoor unit if you put a check
mark here. This is linked with the “O/D unit
demand Valid” (“Setting” dialogue) (P.93)
setting.
F: The “Setting” dialogue is displayed when you
touch this.
A
CB
E
F
D
Demand settings on the outdoor unit [O/D unit demand settings]
To Next Page
Loading...
