99
Settings for energy saving
Energy saving
Item Explanation
Mode Set the operating mode to fan.
Set either [Fan] or [----]*.
Set T.
Set the temperature with
and .
Set “±1” or “±2”, at 1 °C steps between 16 °C
and 28 °C*.
Fan
Use
to set the fan speed.
Set “Auto”, “High”, “Mid.”, or “Low”*.
I/D unit cyclic
Valid
The indoor unit cycling control function is
enabled for the selected indoor unit if you put a
check mark here.
* When left blank, that item does not cause any operation.
5
Touch [Register].
z The “Setting” dialogue closes.
z To cancel the settings, touch [Cancel].
5
6
Set other indoor units.
z Repeat steps 3 to 5.
7
Touch [Timer set.].
z The “Term setting” dialogue is displayed.
7
8
Touch the number.
z You can set 4 different time slots.
8
9
Set the times.
z The time on the left is the control start time. The time on
the right is the control end time.
z Use to set the time. Hours can be set in the
range 0 to 23, and minutes may be either “00” or “30”.
9
10
Set the control interval.
z Select “3 min.”, “4 min.”, or “5 min.”.
z Repeat steps 7 to 9 to set for numbers [1] to [4].
10
Continued on next page
Control operation at regular intervals [I/D unit cyclic]
To Next Page
Loading...
