Panasonic FP E Series - Page 322

12-30
(A: Available, N/A: Not available)
Register
No.
Name Descriptions
Read-
ing
Writ-
ing
DT90123 Not used -N/AN/A
DT90124
COM1 SEND/RECV
instruction end code
For details, refer to Programming Manual
(F145 and F146).
N/A N/A
DT90125
COM2 SEND/RECV
instruction end code
For details, refer to Programming Manual
(F145 and F146).
N/A N/A
DT90126
Forced Input/Outptu
unit No.
Used by the system N/A N/A
DT90127
to
DT90139
Not used -N/AN/A
DT90140
The number of times the receiving operation is
performed.
DT90141
The current interval between two receiving
operations: value in the register x 2.5ms
DT90142
The minimum inerval between two receiving
operations: value in the register x 2.5ms
DT90143
The maximum interval between two receiving
operations: value in the register x 2.5ms
DT90144
The number of times the sending operation is
performed.
DT90145
The current interval between two sending
operations: value in the register x 2.5ms
DT90146
The minimum interval between two sending
operations: value in the register x 2.5ms
DT90147
MEWNET-W0
PC(PLC) link 0 status
The maximum interval between two sending
operations: value in the register x 2.5ms
AN/A
DT90148
The number of times the receiving operation is
performed.
DT90149
The current interval between two receiving
operations: value in the register x 2.5ms
DT90150
The minimum inerval between two receiving
operations: value in the register x 2.5ms
DT90151
The maximum interval between two receiving
operations: value in the register x 2.5ms
DT90152
The number of times the sending operation is
performed.
DT90153
The current interval between two sending
operations: value in the register x 2.5ms
DT90154
The minimum interval between two sending
operations: value in the register x 2.5ms
DT90155
MEWNET-W0
PC(PLC) link 1 status
(32k type only)
The maximum interval between two sending
operations: value in the register x 2.5ms
AN/A