FP Modem-EU Technical Manual
3.5 User Profiles and Factory Settings
3.5 User Profiles and Factory Settings
The following commands recall and/or store the user profiles and factory settings of the modem:
Command Function
AT&V
The modem outputs three different configuration profiles: the currently active profile "ACTIVE
PROFILE", the stored profile 0 "STORED PROFILE0" and the stored profile 1 "STORED PROFILE1".
They contain the most important settings.
AT&W
AT&W0
With the command AT&W you can save the current settings in profile 0, such that they are recalled
upon the next power up or ATZ.
AT&W is identical with AT&W0.
AT&W1
This command stores the current settings in the second stored profile 1 in case a second
configuration should be saved.
ATZ
ATZ0
Recall profile 0. Same as on power up (DIP4 = OFF).
ATZ1
Recall profile 1.
AT&F
Recall factory settings. You can also use the DIP4 switch (see "
DIP Switches" on page 12).
AT&Y0
Reload profile 0 with power up (default).
AT&Y1
Reload profile 1 with power up.
The factory settings were defined as follows:
• Dial line, asynchronous, AT commands
• Automatic detection of error correction/data compression, transmitting and receiving
buffers active
• Automatic detection of the type of modulation 1200-14400 bps
(V.32bis/V.32/V.22bis/V.22)
• Command echo active, report codes indicate modulation speed
• Function to accept calls automatically = ON
• Flow control (RTS/CTS handshake switched off)
ACTIVE PROFILE:
E1 F0 L2 M1 Q0 R0 T V1 W2 X3 Y0 &C1 &D0 &K0 &L0 &M0 &N0 &R0 &S0 &X0 &Y0
%A000 %B1 %C0 %E1 %F0 %G0 %K1 %P0 %S0 \A3 \C0 \E0 \G0 \J0 \K6 \N3 \T000
\X0
*W0
S00:001 S01:000 S06:003 S07:045 S08:002 S09:006 S10:014 S11:085 S12:050
S16:2FH S18:000 S21:20H S22:66H S23:27H S25:005 S26:001 S27:00H S28:00H
S29:04H S30:000 S80:000 S91:000 S92:013 S93:020 S94:013 S104:000
37
To Next Page
Loading...
