Remote Networking with Windows
FP Modem-EU Technical Manual
6.1 Modem Setup for FP Web-Server and Windows
This chapter informs you on how to set up Windows 95/98 or Windows NT to communicate via
FP Modem-EU and dial-up networking with the PPP-Server of the FP Web-Server.
PLC/FP Modem-EU setup
• The FP Modem-EU should use the factory setting (AT&F&W)
• Use a 1:1 cable to interconnect FP Modem-EU and FP Web-Server
• Configure the PPP-Server of the FP Web-Server as in the examples
Windows computer setup
• TCP/IP network protocol is needed (control panel, network)
• Modem installation under Windows using the appropriate .INF file
• Dial-up network installation as for ISP access via modem
The following screenshots were taken from a Windows NT operating system.
The layout of other Windows operating systems may differ slightly.
82
To Next Page
Loading...
