FP Modem-EU Technical Manual
3.11 Terminating the Handshaking Phase
3.11 Terminating the Handshaking Phase
At the beginning of each connection procedure, a handshake phase is executed automatically
in order to determine the optimum transmission speed. The handshake phase might take a few
seconds.
By default, the interruption of the handshake phase by a character at the RS232C (i.e. the
keybreak function) is inactive and the handshake phase can only be terminated by the DTR
signal (if not deactivated with &D0).
With the AT%K0 command, the keybreak function can be enabled again.
49
To Next Page
Loading...
