Characters,
Factory Default
Setting Item, Function, Setting Range
Communication speed
• Selects a communication speed equal to that of the host computer.
• Selection item:
9600 bps
19200 bps
38400 bps
[70]
Available only when Serial communication is specified.
Serial communication can be specified only for the KT4R model.
Data bit/Parity
• Selects data bit and parity.
• Selection item:
8 bits/No parity
7 bits/No parity
8 bits/Even
7 bits/Even
8 bits/Odd
7 bits/Odd
[71]
Available only when Serial communication is specified.
Serial communication can be specified only for the KT4R model.
Stop bit
• Selects the stop bit.
• Selection item:
1 bit
2 bits
[72]
Available only when Serial communication is specified.
Serial communication can be specified only for the KT4R model.
[73] Response delay time
• Response from the controller can be delayed after receiving command from the
host computer.
If Response delay time is changed via software communication, the changed delay
time will be reflected immediately.
• Setting range: 0 to 1000 ms
Available only when Serial communication is specified.
Serial communication can be specified only for the KT4R model.
[74] Step time unit
• Selects the Step time unit for the Program control.
• Selection item:
Hours:Minutes
Minutes:Seconds
Available only when Program control is selected in [OUT/OFF key function].
(*1) The placement of the decimal point follows the selection.
To Next Page
Loading...
