Characters,
Factory Default
Setting Item, Function, Setting Range
[88] Indication time
• Sets time from no operation status until Displays are switched off.
Displays relight by pressing any key while in OFF mode.
When input error (Overscale, Underscale) or burnout has occurred, Displays are
lit, and error codes are displayed.
If errors are cancelled, Displays are unlit after indication time has passed again.
• Setting range: 00:00 to 60:00 (Minutes:Seconds)
When set to 00:00, Displays remain ON.
Controller/Converter function
• Selects either controller or converter function.
• Selection item:
Controller
Converter
[89]
Available only when OUT1 is Direct current output.
To Next Page
Loading...
