Default
Starting at 101
Value Range
Max. 5 digits (consisting of 0–9)
Maintenance Console Location
6.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
3.25 [1-1] Slot—Port Property - Extension Port—Connection Command
Feature Manual References
None
Extension Name
Specifies the name of the extension.
Default
Not stored.
Value Range
Max. 20 characters
Maintenance Console Location
6.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
None
Feature Manual References
None
Wireless XDP
Specifies the extension number of the PS with which Wireless XDP Parallel Mode is established. To enable
Wireless XDP Parallel Mode, the PS must be turned off once and then turned on after assigning this setting.
This setting is not available when the software is in Batch mode. In addition, a PS with PDN or SDN buttons
cannot be used for Wireless XDP Parallel Mode.
When changing the port type of an extension port in DPT Type—Type on the 3.24 [1-1] Slot—Port
Property - Extension Port screen, the Wireless XDP setting must be deleted first.
Default
Not stored.
550 PC Programming Manual Document Version 2009-12
6.1 [4-1-1] Wired Extension—Extension Settings
To Next Page
Loading...
