Incoming Call Wait Timer for Extension Caller ID
Specifies the length of time that the ringing for a call is delayed when the call follows immediately after the
previous unanswered call. When receiving two calls in quick succession (e.g., when a call waiting in a queue
is directed to an extension immediately after the previous unanswered call stops ringing), some SLTs require
a pause, after the first call stops ringing, to receive the second call’s Caller ID information.
Default
0
Value Range
0–15 s
Maintenance Console Location
6.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
None
Feature Manual References
3.1.3 Caller ID
Wrap-up Timer
Specifies the length of time that must pass after completing a call before an extension will accept another call
when logged in as a member of an Incoming Call Distribution Group.
This timer is used when " Options—Wrap-up Timer based on" is set to "Extension" in 5.15 [3-5-3]
Incoming Call Distribution Group—Miscellaneous.
Default
0 s
Value Range
0–3000 s
Maintenance Console Location
6.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
5.13 [3-5-1] Incoming Call Distribution Group—Group Settings—Member List—
Wrap-up Timer
5.15 [3-5-3] Incoming Call Distribution Group—Miscellaneous— Options—Wrap-up Timer based on
Feature Manual References
9.1.3 ICD Group Features—Log-in/Log-out
582 PC Programming Manual Document Version 2009-12
6.1 [4-1-1] Wired Extension—Extension Settings
To Next Page
Loading...
