Modify Command
Specifies the commands to modify the user-dialed number to access the carrier. For details of each command,
see the Feature Manual.
Default
CH
Value Range
Max. 16 characters (consisting of 0–9, *, #, C, P, A, G, I and H)
Maintenance Console Location
10.6 [8-5] Carrier
Programming Manual References
None
Feature Manual References
1.1.3 ARS (Automatic Route Selection)
Carrier Access Code
Specifies the carrier access code. The carrier access code can be added to the user-dialed number by
specifying "C" in Modify Command on this screen.
Default
Not stored.
Value Range
Max. 32 digits (consisting of 0–9, *, #, and P [Pause])
Maintenance Console Location
10.6 [8-5] Carrier
Programming Manual References
None
Feature Manual References
1.1.3 ARS (Automatic Route Selection)
TRG 01–TRG 64
Selects the trunk groups that connect to the carrier.
762 PC Programming Manual Document Version 2009-12
10.6 [8-5] Carrier
To Next Page
Loading...
