5.7.3 Setting LLDP Parameters
LLDP-MED
is a technique for IP telephones to obtain VLAN settings automatically from a network device, such
as a Network Switch.
If you are using an IP telephone equipped with two LAN ports, the primary and secondary ports of the IP
telephone can be placed on different VLANs by assigning a separate VLAN ID to each port. Follow the
procedure below for all IP-PTs on the network, using appropriate VLAN IDs.
Note
• This feature is available only for
KX-NT551, KX-NT553, and KX-NT556 IP-PTs.
• VLAN settings configured through PT programming have priority over VLAN settings configured
through the LLDP-MED function.
• To enable or disable the sending of LLDP packets from the PBX, consult your dealer.
Document Version 2016-03 Installation Manual 207
5.7.3 Setting LLDP Parameters
To Next Page
Loading...
Need help?
General