5.7.5 Configuration of IP Ports
A
KX-NT300 series IP-PT user, KX-NT500 series IP-PT user, or KX-NT265 IP-PT user can configure the port
number of PTAP, DHCP, and FTP ports. Consult your network administrator to check whether the configuration
of the IP ports is required.
Follow the procedure below to configure the port number of the IP ports.
Note
• If
you wish to change the port number back to default, enter 0 as the port number for the desired port.
• To delete 1 character, use "CLEAR" for KX-NT300 series IP-PTs and KX-NT500 series IP-PTs, or use
[TRANSFER] for KX-NT265, KX-NT321 and KX-NT551.
Document Version 2016-03 Installation Manual 213
5.7.5 Configuration of IP Ports
To Next Page
Loading...
Need help?
General