Pre-installing stacked Expansion units connected to the EXP-M card
Once an EXP-M card has been added to the physical shelf on the Slot screen, you can pre-install stacked
Expansion units connected to the EXP-M card.
1. Log in to Web Maintenance Console. For details, refer to "Connecting to Web Maintenance Console" in
"5.3 Starting Web Maintenance Console".
2. Click Setup ® PBX Configuration ® Configuration ® Slot.
3. Place the mouse cursor over the EXP-M card, and in the menu that appears, click Pre-Install.
4. Select the Expansion unit connected to connection port 1 of the EXP-M card, and then click the arrow
button.
5. If a second stackable Expansion units is connected to connection port 2 of the EXP-M card, click the arrow
button.
6. Click OK when finished to complete pre-installation.
Programming Expansion unit
To program Expansion Units that are stacked with the Main Unit, use Web Maintenance Console.
To log in to Web Maintenance Console, refer to "Connecting to Web Maintenance Console" in "5.3 Starting
Web Maintenance Console".
For more information about programming Expansion unit, refer to the PC Programming Manual.
Document Version 2016-03 Installation Manual 255
6.1 Methods of Stacking Expansion Units
To Next Page
Loading...
Need help?
General