EasyManua.ls Logo

Panasonic WV-SW355

Panasonic WV-SW355
130 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
128
128 129
DependingontheOSinstalledonthePC,thefollowingmayoccur.Followtheinstructionsbelowwhenthefollow-
ing has occurred. By performing the following solutions, other applications and the security level may not be
affected.
The "Information Bar" expressed in the following symptom and solutions will be displayed just below the address
bar only when there is information to communicate.
Information Bar
Symptom Cause/solution
Reference
pages
The following message is dis-
played on the information bar.
"Pop-up blocked. To see this
pop-up or additional options,
click here…"
• Clicktheinformationbarandselect"AlwaysAllowPop-
upsfromThisSite…".Thedialogwindowsaying"Allow
pop-upsfromthissite?"willbedisplayed.Clickthe[Yes]
button.
The following message is dis-
played on the information bar.
"This site might require the fol-
lowing Active X control
'nwcv4Ssetup.exe' from
'Panasonic System Networks
Co.,Ltd.'. Click here to install..."
• Clicktheinformationbarandselect"InstallActiveX
Control".
The "Security Warning" window will be displayed. Click
the "Install" button on the displayed "Security Warning"
window.
An unnecessary status bar or
scroll bar is displayed on the
pop-up window.
• Click"InternetOptions…"under"Tools"ofthemenubar
of Internet Explorer, and then click the [Security] tab. Click
"Internet" in the "Select a Web content zone to specify its
securitysettings:"section.Then,clickthe[Custom
Level…]buttontoopenthe"SecuritySetting"window.
Under "Miscellaneous", select "Enable" for "Allow script-
initiated windows without size or position constraints".
Clickthe[OK]button.
When the warning window is displayed, click the [Yes]
button.
Images are not fit in the frames.
• When"120DPI"isnotselectedfor"DPIsetting",they
may not be displayed correctly.
Click the "Settings" tab on the "Properties" window of
"Screen" (in the control panel), and then click the
[Advanced] button. Change the "DPI setting" to "Large
size (120 DPI)".

Table of Contents

Related product manuals