Parker 590 series - Setpoint Sum 2

Programming Your Application 6-49
590 Series DC Digital Converter
SETPOINT SUM 2
Setpoint Sum 2 is a general purpose
summing and ratio block. Additional
outputs are provided to gain access to each
of Input 0 and Input 1 channel sub-
calculations.
SETPOINT SUM 2
–
SPT. SUM 2 [451]
–
0.00%
0.00 %
–
[444] INPUT 0
–
1.0000
–
[447] RATIO 0
–
1.0000
–
[448] DIVIDER 0
–
0.00 %
–
[443] INPUT 1
–
1.0000
–
[446] RATIO 1
–
1.0000
–
[466] DIVIDER 1
–
0.00 %
–
[445] INPUT 2
–
100.00 %
–
[449] LIMIT
–
–
OUTPUT 0 [491]
–
–
OUTPUT 1 [492]
–
MMI Menu Map
1
SETUP PARAMETERS
2
SPECIAL BLOCKS
3
SETPOINT SUM 2
INPUT 2
INPUT 1
INPUT 0
RATIO 1
RATIO 0
DIVIDER 1
DIVIDER 0
LIMIT
SPT SUM OUTPUT
Parameter Descriptions
INPUT 0
Range: -300.00 to 300.00 %
Input 0 value. By default this is not connected to any analog input.
RATIO 0
Range: -3.0000 to 3.0000 %
Input 0 scaling.
DIVIDER 0
Range: -3.0000 to 3.0000 %
Input 0 scaling. Dividing by 0 (zero) results in a zero output.
INPUT 1
Range: -300.00 to 300.00 %
Input 1 value. By default this is connected to analog input 1 (A2).
RATIO 1
Range: -3.0000 to 3.0000 %
Analog input 1 scaling.
DIVIDER 1
Range: -3.0000 to 3.0000 %
Analog input 1 scaling. Dividing by 0 (zero) results in a zero output.
INPUT 2
Range: -300.00 to 300.00 %
Input 2 value. By default this is not connected to any analog input.
LIMIT
Range: 0.00 to 200.00 %
The Setpoint Sum programmable limit is symmetrical and has the range 0.00% to 200.00%.
The limit is applied both to the intermediate results of the RATIO calculation and the total
output.
OUTPUT 0
Reserved parameter for use by Parker SSD Drives.
OUTPUT 1
Reserved parameter for use by Parker SSD Drives.
SPT. SUM 2
Range: -200.00% to 200.00%
(SPT SUM OUTPUT)
Main output of Setpoint Sum 2.
This output is connected using the SYSTEM / CONFIGURE I/O / BLOCK DIAGRAM menu.