Parker 590 series - The Default Application; Block Diagrams

The Default Application 15-1
590 Series DC Digital Converter
15THE DEFAULT APPLICATION
Block Diagrams
The Converter is supplied with a pre-programmed set of parameters providing for basic speed
control. The following block diagrams show this factory set-up.
If you make any permanent changes to the block diagram, remember to update the non-volatile
memory within the Converter by performing a PARAMETER SAVE. Refer to Chapter 5: “The
Man-Machine Interface (MMI)” - Saving Your Application.
To return to the default application, refer to Chapter 5: “The Man-Machine Interface (MMI)” -
Special Key Combinations.