Standard and Optional Equipment 13-11
590 Series DC Digital Converter
Optional Equipment
Contact your local Parker SSD Drives office to order optional equipment.
Item Part Number
EMC Installation Guidelines for Modules and Systems
A Parker SSD Drives application manual detailing EMC requirements
HA388879
590 Digital Section Control
A Parker SSD Drives application manual detailing the use of the
block diagram to implement open and closed loop control of driven
web section rolls
HA388664
590 Digital Closed Loop Centre Winder
A Parker SSD Drives application manual detailing the use of the
block diagram to implement closed loop centre winders
HA388202
ConfigEd Lite
Parker SSD Drives’ Windows-based block programming software
Order by name
External AC Supply (RFI) Filter
For Converters without internal filters, on cable runs in excess of 25
metres
Refer to Chapter 11:
“External AC Supply
(RFI) Filters” for Part
Numbers
Microtach Option Board
Two board types for connecting to a plastic or glass fiber Microtach
encoder
• Glass
• Plastic
AH386025U001
AH386025U002
Encoder Option Board
A board to interface to a wire-ended encoder
AH387775U001
(universal)
Tacho Calibration Option Board
A switchable calibration board for interfacing to AC/DC analog
and/or digital tachogenerators
AH385870U001
Comms Option Board (P1) Board
Two board types for supporting EI BYSYNCH or PROFIBUS
communication protocols for connection to other equipment.
• EI BYSYNCH (RS422, RS485)
• PROFIBUS
AH385826U001
AH389918U001
Table 0-1 Optional Equipment
Speed Feedback Option Boards
Each option board below is shown with the correct selection for the
SPEED FBK SELECT parameter.
The selections are ARM VOLTS FBK, ANALOG TACH,
ENCODER and ENCODER/ANALOG.
(ARM VOLTS FBK is default and requires no option board).
MMI Menu Map
1
SETUP PARAMETERS
2
SPEED LOOP
SPEED FBK SELECT
To Next Page
Loading...
