12-12 Certification for the Converter
590 Series DC Digital Converter
Certificates
590A/D/L (35 - 800 Amps)
EC DECLARATIONS OF CONFORMITY
Date CE marked first applied: 09/01/98 Issue C 07/02/07
EMC Directive
Low Voltage Directive
Issued for
compliance
with the EMC
Directive when
the unit is used
as relevant
apparatus.
In accordance with the EEC Directive
2004/108/EC
We Parker SSD Drives, address as below,
declare under our sole responsibility that the
above Electronic Products when installed and
operated with reference to the instructions in
the Product Manual (provided with each piece
of equipment) is in accordance with the
relevant clauses from the following standard:-
* BSEN61800-3 (2004)
In accordance with the EEC Directive
2006/95/EC.
We Parker SSD Drives, address as below,
declare under our sole responsibility that the
above Electronic Products when installed and
operated with reference to the instructions in
the Product Manual
(provided with each piece of equipment), is in
accordance with the following standard :-
EN50178 (1998)
The drive is CE
marked in
accordance with
the low voltage
directive for
electrical
equipment and
appliances in the
voltage range
when installed
correctly.
MANUFACTURERS DECLARATIONS
EMC Declaration
Machinery Directive
This is
provided to aid
your
justification for
EMC
compliance
when the unit
is used as a
component.
We Parker SSD Drives, address as below,
declare under our sole responsibility that the
above Electronic Products when installed and
operated with reference to the instructions in
the Product Manual (provided with each piece
of equipment) is in accordance with the
relevant clauses from the following standard:-
* BSEN61800-3 (1997)
The above Electronic Products
are components to be incorporated into
machinery and may not be operated alone.
The complete machinery or installation using
this equipment may only be put into service
when the safety considerations of the Directive
89/392/EEC are fully adhered to.
Particular reference should be made to
EN60204-1 (Safety of Machinery - Electrical
Equipment of Machines).
All instructions, warnings and safety
information of the Product Manual must be
adhered to.
Since the
potential hazards
are mainly
electrical rather
than mechanical,
the drive does not
fall under the
machinery
directive.
However, we do
supply a
manufacturer's
declaration for
when the drive is
used(as a
component) in
machinery.
Dr Martin Payn (Conformance Officer)
To Next Page
Loading...
