Parker 590 series - Page 169

Parameter Specification Table 10-1
590 Series DC Digital Converter
10 PARAMETER SPECIFICATION TABLE
The headings for the Tag No. table are described below.
Tag A numeric identification of the parameter. It is used to identify the
source and destinations of internal links.
Name The parameter name as it appears on the MMI.
Function
Block
The menu page and function block under which the parameter is
stored.
Minimum
Value
Maximum
Value
This varies with parameter type:
INT The upper and lower limits of the parameter, indicating the
parameter’s true, internally-held, number of decimal (a
reduced number of digits may be shown by the MMI).
BOOL 0 = FALSE, 1 = TRUE
TAG The tag number of any parameter
(May be set to a negative value indicating a feedback link).
WORD 0000 to FFFF (hexadecimal)
ID Serial Communications Mnemonic:
Refer to Chapter 14: “Serial Communications”
Notes
RO Read Only
RW Read/Write
Parameter Types:
INT (Signal) fixed point value - 16 bits
BOOL A Boolean (bit) representing FALSE or TRUE
TAG A value representing a choice of TAG
WORD 16 Bit hexadecimal number