INTRODUCTION
16 IPA Hardware Installation Guide
Input Power Level
120/240 VAC single-phase mains motor input power
120/240 VAC single-phase mains motor input power
Output Power Level
Servo Motor Drives
In the following table, the maximum current is given at 120/240 VAC input, which equates to a motor bus voltage
of 170/340 VDC.
Output Power Level
Continuous Shaft
Output Power
(Watts)
Components
For information about cables, motors, and other motion-control-system components see “Chapter 2 Mechanical
Installation” on page 18.
Options
For the latest additions, see our website at www.parkermotion.com.