PCME STACK 990 User Manual

- PCME STACK 990 MANUAL: 34 -
6 INITIAL SET-UP
6.1 Introduction
This section provides information on initial set-up and operation of the Control Unit. The same
procedure applies to both the Interface Module (Standard System) and Multicontroller (PLUS
System). For advanced configuration procedures refer to the Control Unit Reference Manual.
6.2 Power-Up
Switch on the external power supply to the Control Unit. Check the power-on indicator is on and
the graphical display illuminates. The icon bar is shown as follows:
The required display is selected using the cursor and enter keys:
Selects ‘Multiple Devices’ display
Selects ‘Bar Graph’ display
Selects ‘System Overview’ display
Selects ‘Alarm Log’ display
Selects ‘Graph Data’ display
Selects ‘Quality Assurance / Self Tests’ display
Selects ‘Password Entry’ display
Select ‘Setup’ display
6.3 Checking the Communications Mode
When using the multicontroller for the first time, communication must be established between
the multicontroller and all the sensors in the network. If the multicontroller is being re-
configured, all existing settings can be cleared by performing a ‘Master Reset’.
.

PCME STACK 990 Specifications

General

Brand	PCME
Model	STACK 990
Category	Measuring Instruments
Language	English