pellenc 200 - Page 116

116
56_11_574A
TP12 TP10 TP8 TP6 TP4 TP2
TP1TP3TP5TP7TP9TP11
TP13
"- LEVEL EXPERT- PELLENC POWER TOOL BATTERY" Workshop document
Issue 11/2016 ref. : DOCUMENT ATELIER_BATTERIE_EXP_OUTILS_PELLENC_V2_2016_ENG
- Parameterize the battery (see parameterization software instructions)
- Reassemble the casing
LEVEL 4 - EXPERT LEVEL
-
Before closing the box, make sure to put the cables into the slots provided for this purpose.
-
&KHFNWKDWWKHWDEVDUHLQ¿UP
contact with the board
No. 10 Torx screwdriver
- Tighten the screws on the board in the order shown in the illustration below.
Torque 0.80 Nm (with
inserts)
Torque 0.60 Nm (with
inserts)
- Replace the fuse
TIGHTEN THE SCREWS ON THE CARD IN THE ORDER SHOWN
IN THE ILLUSTRATION BELOW. (FROM TP1 TO TP13)