PENKO SGM710 - Initial Setup and Calibration

4. First use of indicator
SGM700 Digitizer
14
4.1 First use of indicator -Configuration menu structure-
- - - Fun setpoint function settings (not for SGM710)
- - - ACn setpoint action settings (not for SGM710)
- - - dAC Analog output settings
- - - 485 Local bus communication settings (RS485)
- - - Eth Ethernet settings (SGM720 only)
- - - CAn Can bus port settings (SGM730 only)
- - - - Pb Profibus settings (SGM740 only)
- - - 232 RS232 port settings (SGM750 only)
- - - 422 RS422 port settings (SGM750 only)
- - - Ind Indicator settings
- - - rng Multi range/interval settings
- - - FIL Filter settings
- - - dSF Digital filter settings
- - - PCL Pre-calibration settings
- - - CAL Calibration settings
- - - tCL Theoretic calibration
- - - gCL Geographic calibration
- - - CLo Date and time configuration (SGM750 only)
- - - rcL Recall
- - - SoF Firmware update