SGM700 Digitizer
Main Menu -continue-
When done with changing the setpoints press key 3 <2 sec to go back to the
main weigher display
5.2 TAC code (Traceable Acces Code).
The SGM700 has a TAC code inside. TAC code is number of times the indicator
data is changed. When an indicator gets certified this number will be written on
the device and is used by the controlling agency to see if the settings aren’t
changed after sealing.
To check out the TAC code Press key 3 <2 sec. to go into the Main menu.
Press key 1 <2sec. to the dtAC menu and
press key 2 <2sec. to enter.
The following screen will show the actual TAC code.
Press Key 3 <2 sec. to go back to the main menu.
Press key 3 <2 sec. to go back to the main weigher display.
30
To Next Page
Loading...
