PENKO SGM710 - Calibration Settings

SGM700 Digitizer
Configuration Menu -PCL- -continue-
The following screen is visible:
The following screen is visible:
To recall the factory settings press key 3 >2 sec.
To cancel press key 3 <2 sec.
Cancel Recall
The following screen is visible:
Configuration Menu -CAL-
6.15 - - - CAL Calibration settings
In this menu, the Calibration settings can be set. Options are:
79
CAL 1 Add calibraon point
CAL 2 Check weiger informaon
CAL 3 Show/remove calibraon points
CAL 4 Deadload compensaon
CAL 5 Show CAL code