SGM700 Digitizer
First use of indicator -continue-
Calibration Settings -continue-
The indicator now shows CP2 to calibrate the gain point (CP2).
And will automatically jump to:
Use key 1 and key 2 to enter the reference value. Key 1 is used for changing the
number (1-9), key 2 is used for changing the position of the cursor. Load the
weigher with the reference value and press key 3 >2 sec.
Up Down
Left Right Confirm
Done succesfully the following screen is visible:
Press key 3 <2 sec. to go back to Configuration Menu.
Press key 3 <2 sec. to go back to main weigher display.
20
To Next Page
Loading...
