PENKO SGM710 - Firmware Update

SGM700 Digitizer
Configuration Menu -rcl- -continue-
To set all parameters back to factory settings Press key 3 >2 sec.
The device will reboot.
To reset the file system Press key 1 >2 sec.
The following screen is visible. Confirm by pressing key 3 >2 sec.
The device will reboot.
Configuration Menu -SoF-
6.20 - - - SoF Firmware update
In SoF, you can set the SGM700 in boot mode for software update.
Press key 2 <2 sec to enter Boot mode.
The following screen is visible:
Press key 3 >2 sec to set the SGM700 in Boot mode.
94