107
2
Taking Pictures
1
Use the four-way controller (23) to select [Shake
Reduction] in the [A Rec. Mode 2] menu, and press the
four-way controller (5).
A pull-down menu appears.
2
Use the four-way controller (23) to select the Shake
Reduction type, and press the 4 button.
The setting is saved.
The Face Detection function locates faces in the frame and
automatically adjusts the focus and exposure for those faces. You can
change the setting of the function so that the camera will automatically
release the shutter when one or more of the subjects smile. The default
setting is [On] for [Face Detection].
•In 9 (Green) mode, the setting is fixed to [Sensor Shift].
•In N (Handheld Night Snap) mode, the setting is fixed to [Dual].
• [Dual] cannot be set in the following situations. When [Dual] has been
selected, the setting is changed to [Sensor Shift]:
- when . (Fireworks), X (Digital Wide), F (Digital Panorama) or
p mode is selected as the capture mode
- when the sensitivity is set to 3200 or higher
- when g (Self-timer), j (Continuous Shooting), A (Burst
Shooting(L)) or C (Burst Shooting(H)) is selected as the drive mode
- when the flash mode is set to b (Flash On), G (Slow-speed Sync),
F (Flash On + Red-eye), H (Slow-speed Sync+Red-eye) or I
(Trailing Curtain Sync)
- when the picture is taken without pressing the shutter release button
halfway
• For correcting camera shake in C (Movie) or c (Time-Lapse Movie)
mode, use the Movie SR function (p.119).
• When [Dual] is set, the optical correction is used whenever the camera
can correct shaking optically.
• The [Shake Reduction] setting can also be changed using the control
panel.
Setting the Face Detection Function
On The camera detects a person’s face.
Smile
The camera automatically release the shutter when your subject
smiles.
To Next Page
Loading...
Need help?
General
