3
• Do not disassemble or modify the products. This can cause a fire or electric
shock.
• If the generation of smoke or strange odor from the products or other
abnormality occurs, immediately discontinue use and consult a PENTAX
Service Center. Continued use can cause a fire or electric shock.
• If water should happen to get inside the products, consult a PENTAX
Service Center. Continued use can cause a fire or electric shock.
• If you see a lightning flash or hear thunder during use of the battery charger
or AC adapter, unplug the power plug and discontinue use. Continued use
can cause damage to the product, fire, or electric shock.
• Wipe off the plug of the AC adapter if it should become covered with dust.
Accumulated dust may cause a fire.
Caution
• Do not place or drop heavy objects on or forcefully bend the AC plug cord.
Doing so may damage the cord. Should the cord be damaged, consult a
PENTAX Service Center.
• Do not touch or short-circuit the terminal area of the AC plug cord while the
cord is plugged in.
• Do not handle the power plug with wet hands. This can cause an electric
shock.
• Do not drop the products, or subject them to violent impact. This can cause
them to breakdown.
• Do not use the battery charger D-BC106 to charge batteries other than the
rechargeable lithium-ion battery D-LI106. Attempting to charge other types
of batteries may cause an explosion or heating, or may damage the battery
charger.
• To reduce the risk of hazards, use only a CSA/UL certified power supply
cord set, cord is Type SPT-2 or heavier, minimum NO.18 AWG copper,
one end with a molded-on male attachment plug cap (with a specified
NEMA configuration), and the other is provided with a molded-on female
connector body (with a specified IEC non-industrial type configuration) or
the equivalent.
To Next Page
Loading...
Need help?
General
