88
2
Taking Pictures
When the shutter release button is pressed once, three consecutive
pictures at different exposure levels are taken so that you can select the
best one later.
The shooting order is: correct exposure → negative compensation →
positive compensation.
1
Press the four-way controller (2) in capture mode.
The Drive Mode screen appears.
2
Use the four-way controller (45)
or the e-dial to select a drive mode
and press the 4 button.
To select j (Continuous Shooting),
A (Burst Shooting(L)), C (Burst
Shooting(H)), g (Self-timer), Z (2-sec.
Self-timer), C (3 Shot Self-timer),
i (Remote Control), h (0-sec Remote
Control), first select the current mode, press
the four-way controller (3), then use the
four-way controller (45) to select the new
mode.
The camera is ready to take a picture using
the selected drive mode.
To Shoot while Automatically Changing the Exposure (lAuto
Bracketing)
You can change the order of three shots using [2. Bracketing Order] in
the [A Custom 1] menu (p.67).
To Select the Drive Mode
• Focusing may be compromised if you move the camera while the self-
timer lamp is blinking when taking still pictures.
• The flash does not discharge in j, A, C or l mode.
• In the following modes, you cannot select j, A, C, C, or l:
9 (Green), p, S (Fireworks), X (Digital Wide), F (Digital
Panorama), or o (Miniature) mode or when recording a movie.
• The drive mode cannot be selected when N (Handheld Night Snap) is
set.
Cancel
Remote Control
OK
To Next Page
Loading...
Need help?
General
