190
6
Settings
Pixel Mapping is a function for mapping out and correcting defective
pixels in the CCD sensor. Run the Pixel Mapping function if image dots
always seem to be defective in the same place.
1
Press the 3 button in A mode, and press the four-
way controller (5) twice.
The [W Setting] menu appears.
When you press the 3 button in Q mode, [Pixel Mapping]
cannot be selected.
2
Use the four-way controller (23) to select [Pixel
Mapping].
3
Press the four-way controller (5).
The [Pixel Mapping] screen appears.
• Once the start-up screen has been set, it will not be deleted even if the
original image is deleted or the SD Memory Card/built-in memory is
formatted.
• Select [Off] to hide the start-up screen.
• The start-up screen is not displayed when the camera starts up in the
playback mode.
¥ Movies or images taken at f (16-frame shooting) or F (Digital
Panorama) mode cannot be used for the start-up screen.
Correcting Defective Pixels in the CCD Sensor
(Pixel Mapping)
Setting
3/3
Pixel Mapping
Format
MENU
Exit
To Next Page
Loading...
