Pentax OPTIO VS20 - Viewing Images on a Computer

191
6
Settings
4 Use the four-way controller (23)
to select [Pixel Mapping].
5 Press the 4 button.
Defective pixels are mapped and corrected.
You can reset the camera settings to their defaults. Refer to “Default
Settings” (p.216) for the reset settings.
1 Press the 3 button in Q mode.
The [W Setting] menu appears.
When you press the 3 button in A mode, press the four-way
controller (5) twice.
2 Use the four-way controller (23)
to select [Reset].
3 Press the four-way controller (5).
The [Reset] screen appears.
When the battery level is low, [Not enough battery power remaining to
activate Pixel Mapping] is displayed on the monitor. Use the AC adapter
kit K-AC122 (optional) or load a fully charged battery.
Resetting to Default Settings (Reset)
Pixel Mapping
Checks the image sensor
and corrects defective
pixels
Pixel Mapping
Cancel
OK
OK
Setting
2/3
Power Saving
Auto Power Off
3min.
5sec.
Video Out
Brightness Level
MENU
CancelExit
NTSC
Delete all
Reset