Pentax OPTIO VS20 User Manual

94
3
Taking Pictures
1 Press the four-way controller (2) in A mode.
The [Drive Mode] screen appears.
2 Use the four-way controller (45) to select i and press
the four-way controller (3).
3 Use the four-way controller (45)
to select i or h and press the
4 button.
The self-timer lamp begins to blink slowly
and the camera is ready to take a picture
with the remote control.
4 Point the remote control at the remote control receiver
and press the shutter release button on the remote
control.
The focus frame turns green when the subject is in focus and the
camera takes a picture at the following timing.
When i (Remote Control) is selected:
The self-timer lamp blinks quickly and the camera takes a
picture after about three seconds.
When h (0-sec Remote Control) is selected:
The camera takes a picture immediately.
h
0-sec Remote
Control
The shutter will be released immediately when the shutter
release button on the remote control unit is pressed.
Four-way controller
4 button
Shutter release button
Shutter release button
for vertical shooting
OK
O K
OK
OK
MENU
Cancel
C a n c e l
Cancel
MENU
Cancel
C a n c e l
Cancel
MENU
Cancel
C a n c e l
Cancel
MENU
Cancel
C a n c e l
Cancel
MENU
Cancel
C a n c e l
Cancel
Drive Mode
D r i v e M o d e
Remote Control
R e m o t e C o n t r o l
Drive Mode
Remote Control

Pentax OPTIO VS20 Specifications

General

Brand	Pentax
Model	OPTIO VS20
Category	Digital Camera
Language	English