9
Introduction
Cleaning and maintenance instructions
Clean the panels after each use to
maintain the value and usability of the
PERI products over the long term.
Some repair work may also be inevita-
ble due to the tough working condi-
tions. The following points should help
to keep cleaning and maintenance
costs as low as possible.
Do not clean powder-coated or galva-
nized components with steel brushes
or metal scrapers.
Mechanical components, e.g. spindles,
must be cleaned of dirt or concrete
residue before and after use, and then
greased with a suitable lubricant.
Provide suitable support for the com-
ponents during cleaning so that no un-
intentional change in their position is
possible.
Do not clean components suspended
on crane lifting gear.
Any repairs to PERI products are to be
carried out by PERI qualified personnel
only.
PERI UP Flex Reinforcement Scaffold 75 and 100
Instructions for Assembly and Use – Standard Configuration
To Next Page
Loading...
