Input
11 - 7
After sewing the following displays and functions appear on the screen.
● Switch to the next seam section.
The seam section change can be called up
by activating the appropriate function or
by pressing the knee switch (with the appropriate setting of parameter "201",
see Chapter 13.08 Parameter settings).
● Set the seam end or program end.
If entering only one seam (only the right or the left) the program end is set in the desired
seam section.
In the same way as the program end, the seam end is set when entering the right and
left seam. The seam end is set in the first seam and the program end in the second
seam.
● Conclude the input and change to the input of the basic settings.
● Conclude the input and change to programmed sewing.
To Next Page
Loading...
Need help?
General
