Directions For Use
EN 19DVDR70 & DVDR75/0x1 3.
28
Automatic TV channel search
During installation, all available TV channels are searched for and stored. If the channel
assignments of your cable or satellite TV provider change or if you are reinstalling the DVD
recorder, e.g. after moving house, you can start this procedure again. This will replace the stored
TV channels with the new ones.
What does Easy Link do?
With Easylink, you can search for and store TV channels only on the TV set.
These settings are accepted by the DVD recorder. Use this function to start
the transfer of TV channels from the TV set.
?
1 Switch on the TV set. If required, select the programme number for
the DVD recorder.
2 Switch on the DVD recorder using STANDBY/ON m .
3 Press SYSTEM-MENU on the remote control. The menu bar
appears.
4 Select '
A
' symbol with D or C .
5 Select 'Installation' using CH- B or CH+ A and confirm with C .
6 Select 'Autom. search' using CH- B or CH+ A .
7 Press C .
Installation
Autom. search
Searching for TV channels
00 Channels found
Please wait
8 The automatic TV channel search starts. This allows the DVD
recorder to save all available TV channels. This procedure may take
several minutes.
9 When all the TV channels have been found, 'Autom. search
complete' will appear on the TV screen.
0 To end, press SYSTEM-MENU .
You can read about how to search for a TV channel manually in 'Manual TV channel search'.
Installing your DVD recorder
27
2 Switch on the DVD recorder using STANDBY/ON m .
3 Press the SYSTEM-MENU button on the remote control. The menu
bar appears.
4 Select '
A
' symbol with D or C .
5 Select 'Installation' using CH- B or CH+ A and confirm with C .
6 Select line 'Follow TV' with CH- B or CH+ A . and confirm with
the C button.
7 Confirm the message on the screen with OK .'TV 01' will appear in
the DVD recorder display.
TV 01
8 Select programme number '1' on the TV set.
a I cannot switch my TV set to programme number '1'
b If you have connected additional devices to the EXT 2 AUX-I/O socket,
please disconnect these devices. Other connected devices may have
switched the TV set to the programme number of the scart socket.
Problem
9 Confirm with OK on the DVD recorder remote control.
'WAIT' will appear in the display. The DVD recorder compares the TV
channels on the TV set and the DVD recorder.
If the DVD recorder finds the same TV channel as on the TV set it
stores it at 'P01'.
a 'NOTV' will appear in the display. The DVD recorder is not
receiving a video signal from the TV set.
b Chech the connectors at both ends of the scart cable.
b Check your TV's operating instructions to see which scart socket is used
for video signals.
b If the problem persists, you won't be able to use this feature.
Please read 'Adding and clearing TV channels manually'.
Problem
0 Wait until for example 'TV 02' appears in the display.
TV 02
A Select the next programme number on the TV set, e.g. '2'.
B Confirm with OK on the DVD recorder remote control.
Deleting sorting
You can delete incorrect TV channel sorting by pressing D .
Tip
C Repeat steps 0 to B until you have assigned all the TV channels.
À To end, press SYSTEM-MENU .
ENGLISH
Installing your DVD recorder
To Next Page
Loading...
