Directions For Use
EN 37DVDR70 & DVDR75/0x1 3.
64
Timer
ShowView system
Date
01
Prog.
BBC1
Start
20:15
VPS
PDC End
21:30
Rec
Mode
M2
Mo-Fr/Weekly
Press SELECT
To store
Press OK
6 The decoded data appears after confirmation. You can go back and
change the data. Select the appropriate input field with C or D .If
required, make changes using CH+ A , CH- B or the number
buttons 0..9 .
'Switching on 'VPS/PDC' in the 'Start' input field
Select the 'Start' input field using C . Using SELECT switch on 'VPS/PDC'
('*' lights up). If you press SELECT again, you will switch 'VPS/PDC' off ('*'
goes out).
Changing the recording mode in input field 'End'
Select the 'End' input field using C .
Use SELECT to select the recording mode 'M1, M2, M2x, M3, M4, M6'.
Tip
7 If all information is correct, press the OK button. The programming
information is stored in a TIMER block.
8 To end, press TIMER .
9 Insert a recordable disc (one without write protection).
The disk you have inserted will be checked.
0 Switch the DVD recorder off with STANDBY m .
The programmed recording will only function properly if the DVD
recorder has been switched off using the STANDBY m button.
If any of the TIMER blocks are in use, 'TIMER' will light up on the recorder display.
Programming a recording (TIMER)
63
Programming recordings with the
ShowView
®
System
Thanks to this programming system, you no longer need to tediously enter the date, programme
number, start and end times. All the information needed by the DVD recorder for programming
is contained in the ShowView
®
programming number. This 9-digit ShowView
®
number is found in
most TV listings magazine.
1 Switch on the TV set. If required, select the programme number for
the DVD recorder.
2 Press TIMER on the remote control.
The programming method selected last is marked.
3 Select 'ShowView system' using CH- B or CH+ A and confirm
with C .
4 Enter the entire ShowView number. This number is up to 9 digits long
and can be found next to the start time of the TV programme in your
TV listings magazine.
e.g.: 5-312-4 or 5,312 4
Enter 53124 for the ShowView-number.
If you make a mistake, you can clear your instructions with CLEAR .
Timer
ShowView system
ShowView number
---------
Mo-Fr/Weekly
Press SELECT
To store
Press OK
Selecting daily/weekly recordings
Using SELECT , select from the following options:
'Mo-Fr': Repeated daily recordings (Monday to Friday).
'Weekly': Repeated weekly recordings (every week on the same day).
Tip
5 Confirm with OK .
a The following message appears on the screen: 'Please enter
programme number'
b The programme number of the TV channel has not yet been assigned to
the ShowView number. Use C , D or the number buttons 0..9 on the
remote control to select the appropriate programme number (name) of the
TV channel and confirm with OK .
a
The following message appears on the screen: 'ShowView number
wrong'
b The entered ShowView number is incorrect. Correct your entry or cancel
using the SYSTEM-MENU button.
b Check the time/date (see 'Setting the time & date' in 'Installing your DVD
recorder').
a
The following message appears on the screen: 'Weekend
programming not possible'
b A daily recording was entered for the wrong day. Daily programming can
only be used for recordings to be made from Monday to Friday.
Problem
ENGLISH
Programming a recording (TIMER)
To Next Page
Loading...
