Telemetry Functions at the Information Center
9-12 Telemetry Functions at the Information Center & TeleMon
SpO
2
Mode Determine the transceiver SpO
2
behavior.
Note—Pulse Rate and Pleth
Wave are not available in Spot
Check.
Spot Check - Provides
manual measurements so the
clinician can check as
needed. Measurement
initiated by plugging the
SpO
2
cable into the
transceiver or by selecting
Spot Check SpO
2
icon in the
Patient Window. No pulse or
successful/failed
measurement tones are
generated when measurement
is initiated at Information
Center.
Continuous - Sends an SpO
2
parameter value to the
Information Center every
second. If selected, Pulse
Rate and Pleth Wave may
also be sent.
Spot Check
Unit Settings - Telemetry Setup
Control Function Settings
Factory
Default
To Next Page
Loading...