24 Version: 2.0.0 MS205Equ C-863 Mercury Controller
3. Connect the following to the C-863:
− the included wide-range-input power supply (not connected to the wall
socket via the power cord) to the 15-30 VDC connection. Details see
"Connecting Power Supply".
− the stage to the DC Motor only socket. Details see "Connecting Stage"
(p. 35).
− the PC via the RS-232 interface (RS-232 In socket) or via the USB
interface. Details see "Connecting PC" (p. 36).
4. Check the DIP switch settings (p. 42) and adapt them to your application if
necessary. Controller address 1 must be set.
5. Switch on the C-863 (p. 45) by connecting the power cord of the wide-range-
input power supply to the power socket.
6. Start PIMikroMove on the PC.
7. Establish communication between the C-863 and the PC in PIMikroMove via
the RS-232 interface or the USB interface. Details see "Establishing
Communication" (p. 46).
8. If in PIMikroMove the Select connected stages step is displayed, select the
stage type of the stage connected:
If on the right in the window in the Controller axes list the correct stage type
is already listed in the Current stage type column:
− Click on OK.
If the listed stage type is not correct:
a) Mark the stage type in the Stage database entries list.
b) Click Assign.
c) Confirm the selection with OK to load the parameter settings for the
selected stage type from the stage database to the volatile memory of the
C-863.
To Next Page
Loading...
Need help?
General
