80 Version: 2.0.0 MS205Equ C-863 Mercury Controller
4. Expand the view of the single axis window by clicking on the > button at the
right edge of the window.
Figure 21: PIMikroMove: Expanded single axis window
5. Enter new values for the stage parameters:
a) If the parameter to be modified is not included in the list on the right side
of the window, click on Select parameters... and add it to the list.
b) Type the new parameter value into the appropriate input field in the list.
c) Press the Enter key of the PC to transfer the parameter value to the
volatile memory of the controller. When this is done, the entry changes its
color from blue to black.
6. Click the Save parameters… button below the parameter list.
The Save Parameters as User Stage Type dialog opens.
7. In the Save Parameters as User Stage Type dialog, save the modified
parameter values as a new stage type:
a) Leave the entry in the Parameters of axis: field unchanged.
b) Enter the name for the new stage type in theSave as: field.
c) Click on OK.
The new stage type has been saved in the PI_UserStages2.dat stage
database. The display of the stage type connected has been updated in the
single axis window and in the main window of PIMikroMove. The new stage
type is available with immediate effect for selection in the Select connected
stages step too.
To Next Page
Loading...
