Removing the stator
- Remove the two pickup screws and the screw
holding the wiring support and the three stator
clamping screws shown in the figure.
- Remove the stator and its wiring.
Refitting the stator
- Refit the stator and flywheel carrying out the re-
moval procedure in reverse, tightening the retain-
ers to the specified torque.
Locking torques (N*m)
Stator assembly screws (°) 3 ÷ 4
Refitting the flywheel cover
- Position the spline clip on the crankshaft and ori-
ent the end as shown in the figure.
Engine MSS X9 Evolution 250
ENG - 102
To Next Page
Loading...
