We inform you that a plug has been introduced starting with frame number ZAPM2300004501445 in
order to prevent the possibile wear of the battery due to its rubbing against the rivets of the helmet
compartment.
Turn signal lights malfunction
TURN INDICATOR NOT WORKING
Possible Cause Operation
Electronic ignition device failure With the key switch set to "ON" jump the contacts 1 (Blue -
Black) and 5 (Red/Blue) on the control unit connector. If by
operating the turn indicator control the lights are not steadily
on, replace the control unit; otherwise, check the cable harness
and the switch.
Steering and suspensions
Controls
STEERING CONTROLS AND SUSPENSIONS
Possible Cause
Operation
Torque not conforming Check the tightening of the top and bottom ring nuts. If irregu-
larities in turning the steering continue even after making the
above adjustments, check the seats on which the ball bearings
rotate: replace them if they are recessed or if the balls are flat-
tened.
Steering hardening Check the tightening of the top and bottom ring nuts. If irregu-
larities continue in turning the steering even after making the
above adjustments, check the seats in which the ball bearings
rotate: replace them if they are recessed or if the balls are flat-
tened.
Malfunctions in the suspension system If the front suspension is noisy, check: the efficiency of the front
shock absorbers; the condition of the ball bearings and relevant
lock-nuts, the limit switch rubber buffers and the movement
bushings. In conclusion, check the tightening torque of the
wheel hub, the brake calliper, the shock absorber disk in the
attachment to the hub and the steering tube.
Seal fault or breakage Replace the shock absorber Check the condition of wear of the
steering covers and the adjustments.
MSS X9 Evolution 250 Troubleshooting
TROUBL - 51
To Next Page
Loading...
