Replacement
Hub oil replacement
- Remove the oil loading cap «A».
- Remove the oil drainage cap «B» and let the oil
drain out completely.
- Tighten the drainage cap again and fill the hub
with oil (about 150 cc.).
Air filter
Remove the air cleaner cap after undoing the re-
tainer screws, then extract the filter.
- Wash with water and neutral soap.
-Dry with a clean cloth and short blasts of com-
pressed air.
- Soak with a mixture of 50% petrol and 50% SE-
LENIA AIR FILTER OIL.
-Drip dry the filter and then squeeze it between the
hands without wringing.
CAUTION
NEVER RUN THE ENGINE WITHOUT THE AIR FILTER,
THIS WOULD RESULT IN AN EXCESSIVE WEAR OF THE
PISTON AND CYLINDER.
CAUTION
WHEN TRAVELLING ON DUSTY ROADS, THE AIR FILTER
MUST BE CLEANED MORE OFTEN THAN SHOWN IN THE
SCHEDULED MAINTENANCE CHART.
Engine oil
MSS X9 Evolution 250 Maintenance
MAIN - 39
To Next Page
Loading...
