Pioneer MEP-7000 Service Manual

121
MEP-7000
5
6 7 8
5
6 7 8
A
B
C
D
E
F
Updating Using the USB Storage Device
[2] Procedures for Updating
Copy the updater files you wish to use for updating to a USB storage device.
Note:
Format the USB storage device in FAT/FAT32/HFS+.
(For emergency boot, the format must be FAT/FAT32.)
Updating does not start if updater
files are not found.
Connect the control and drive units.
Startup animation
Update mode display
Display during updating
Order of updating CONTROL UNIT "MAIN"
DRIVE UNIT "SERVO DRIVE"
DRIVE UNIT "MAIN"
Time for updating: Max. 2 minutes
The percentage display shows the progress
of updating.
If a disc is loaded in the DVD/CD drive,
it will be ejected.
In maximum
of 2 minutes
Memo:
Memo:
Memo:
While holding the USB 1 STOP and USB 2 STOP keys of
the drive unit pressed, turn the unit on. (Hold the keys
pressed until the PRO DJ logo on the display disappears.)
When the unit enters Update mode, the USB 1 STOP and
USB 2 STOP keys start flashing rapidly in red.
Updating starts when the USB storage device on which
updater files have been copied is connected to the USB 1
(on the rear) or USB 2 (on the front) connector of the drive
unit.

Pioneer MEP-7000 Specifications

General

Frequency range	4 - 20000 Hz
Channels quantity	- channels
Digital sound processing	- bit
Total Harmonic Distortion (THD)	0.006 %
Dimensions (WxDxH)	483 x 325 x 91 mm
Power consumption (typical)	33 W

Weight and Dimensions

Weight	6100 g