Pitney Bowes SendPro C Auto - Setting Up a Wired Network Connection

Setting up a wired network connection
Use a network cable to connect your SendPro C Auto to the Pitney Bowes Data Center.
Step 1: Plug in your network cable
Plug one end of your network cable to your device and the other end to an internet jack on the wall or a
router.
Step 2: Choose the connection type
Select one of the two connection types supported for this device:
l
DHCP
l
Static IP
DHCP is the most common connection type. Choose DHCP if you are unsure which connection
protocol to use or contact your IT department for advice.
DHCP
1. Tap Settings.
2. Tap Wired.
Connectivity information
Pitney Bowes Operator Guide April 2022 50