Planet MGSW-28240F - Access Control List Configuration

User’s Manual of MGSW-28240F
238
Buttons
: Select the ACL status from this drop down list.
Auto-refresh
: Check this box to refresh the page automatically. Automatic refresh occurs every 3 seconds.
: Click to refresh the page immediate
4.10.2 Access Control List Configuration
This page shows the Access Control List (ACL), which is made up of the ACEs defined on this switch. Each row describes the
ACE that is defined. The maximum number of ACEs is 256 on each switch.
Click on the lowest plus sign to add a new ACE to the list. The reserved ACEs used for internal protocol, cannot be edited or
deleted, the order sequence cannot be changed and the priority is highest.
The Access Control List Configuration screen in Figure 4-10-2 appears.
Figure 4-10-2: Access Control List Configuration Page Screenshot
The page includes the following fields:
Object Description
• Ingress Port
Indicates the ingress port of the ACE. Possible values are:
 All: The ACE will match all ingress port.
 Port: The ACE will match a specific ingress port.
• Policy / Bitmask
Indicates the policy number and bitmask of the ACE.
• Frame Type
Indicates the frame type of the ACE. Possible values are:
 Any: The ACE will match any frame type.
 EType: The ACE will match Ethernet Type frames. Note that an
Ethernet Type based ACE will not get matched by IP and ARP frames.
 ARP: The ACE will match ARP/RARP frames.
 IPv4: The ACE will match all IPv4 frames.
 IPv4/ICMP: The ACE will match IPv4 frames with ICMP protocol.
 IPv4/UDP: The ACE will match IPv4 frames with UDP protocol.
 IPv4/TCP: The ACE will match IPv4 frames with TCP protocol.