Planet MGSW-28240F - LLDP Command; LLDP Configuration; LLDP Mode

User’s Manual of MGSW-28240F
520
6.11 LLDP Command
LLDP Configuration
Description:
Show LLDP configuration.
Syntax:
LLDP Configuration [<port_list>]
Parameters:
<port_list>: Port list or 'all', default: All ports
Example:
Show LLDP configuration of port1~4
MGSW
-28240F:/>lldp configuration 1-4
LLDP Configuration:
===================
Interval : 30
Hold : 3
Tx Delay : 2
Reinit
Delay: 2
Port Mode Port Descr
System Name System Descr System Capa Mgmt Addr CDP awareness
----
-------- ---------- ----------- ------------ ----------- --------- -------------
1 Enabled Enabled Enabled Enabled
Enabled Enabled Disabled
2 Enabled Enabled Enabled Enabled Enabled Enabled
Disabled
3 Enabled Enabled Enabled Enabled Enabled Enabled
Disabled
4 Enabled Enabled Enabled Enabled
Enabled Enabled Disabled
LLDP Mode
Description:
Set or show LLDP mode.
Syntax:
LLDP Mode [<port_list>] [enable|disable|rx|tx]