Planet MGSW-28240F - Qos DSCP Egressremap; Qos Storm Unicast

User’s Manual of MGSW-28240F
547
If port DSCP classification is 'selected', DSCP will be classified based on QoS class and DP level only for DSCP value
with classification mode 'enabled'. DSCP may be translated DSCP if translation is enabled for the port.
Syntax:
QoS DSCP Classification Mode [<dscp_list>] [enable|disable]
Parameters:
<dscp_list>: DSCP (0-63, BE, CS1-CS7, EF or AF11-AF43) list or 'all'
enable : Enable DSCP ingress classification
disable : Disable DSCP ingress classification
(default: Show DSCP classification mode)
Default Setting:
disable
QoS DSCP EgressRemap
Description:
Set or show DSCP egress remap table. This table is used if the port egress remarking mode is 'remap' and the purpose is
to map the DSCP and DP level to a new DSCP value.
Syntax:
QoS DSCP EgressRemap [<dscp_list>] [<dpl_list>] [<dscp>]
Parameters:
<dscp_list>: DSCP (0-63, BE, CS1-CS7, EF or AF11-AF43) list or 'all'
<dpl_list> : DP level list or 'all', default: All DP levels (0-1)
<dscp> : Egress remapped DSCP: 0-63, BE, CS1-CS7, EF or AF11-AF43
QoS Storm Unicast
Description:
Set or show the unicast storm rate limiter.
Syntax:
QoS Storm Unicast [enable|disable] [<packet_rate>]
Parameters: