User’s Manual of MGSW-28240F
3.3 CLI Mode Management
There are two ways for CLI mode management, one is remote telnet, and the other is operating from console port. Remote
telnet is an IP-based protocol, and console port is for user to operate the MGSW-28240F on local only, however their operation
is the same.
The command line user interface is for performing system administration, such as displaying statistics or changing option
settings. Using this method, you can access the Managed Switch remote telnet interface from personal computer, or
workstation in the same Ethernet environment as long as you know the current IP address of the Managed Switch.
Figure 3-1: Remote Telnet and Console Port Interface Management
In Windows system, you may click “Start”, then choose “Accessories”and “Command Prompt”. Please input “telnet
192.168.0.100” and press “enter’ from your keyboard. You will see the following screen (see Figure 3-2) appear.
IP Address:
192.168.0.100
PLANET Managed Switch
PC / Workstation
with
IE Browser
IP Address :
192.168.0.x
RJ-45 / UTP Cable
PC / Workstation
with
Terminal emulation software
Serial Port
PLANET Managed Switch
RS-232
Serial Port
115200,8,n,1
To Next Page
Loading...
